 The upper arrow shows the...  The upper arrow shows the custom heater hose installed.This power steering cooler was created by modifying one from an '86-89 Accord. The '94-95 Accord unit has no cooling fins and makes a U turn on the right, returning to the left side of the car. This one was simply bolted in on the |  This power steering cooler...  This power steering cooler was created by modifying one from an '86-89 Accord. The '94-95 Accord unit has no cooling fins and makes a U turn on the right, returning to the left side of the car. This one was simply bolted in on the |  If your engine is a K24A2...  If your engine is a K24A2 (TSX), like this one, you'll need an `03-`05 Accord throttle body. It's a simple swap and everything plugs right in when you have the RSX-S engine harness on. |
 If you are going to use an...  If you are going to use an EP3 radiator to simplify the hoses, the mounts need to be moved over just a bit. The mounting holes indicate where they were previously. The Full-Race tubular front crossmember lets you use either radiator. |  Once all of the new lines...  Once all of the new lines have been run, the rear Hasport mount is bolted in. |  The rear mount happens to...  The rear mount happens to be the trickiest of the three to connect, so it is recommended this one go on first. The radiator needs to be out of the car so the engine can be forward enough to clear the crossmember (if you're using a lift). The engine is then lifted a bit and pushed back until the Hasport bracket is aligned with the billet mount. |
 The right-side mount is...  The right-side mount is bolted to the frame rail bracket and a pair of bolts goes right into the engine bracket. |  The left side has a new Hasport...  The left side has a new Hasport bracket mounted to the transmission casing, which bolts up to the Hasport billet mount. |  Next up are the axles. Hasport...  Next up are the axles. Hasport and The Driveshaft Shop have the custom length axles needed--just be sure to get the half shaft or jack-shaft with your swap. |