Before the lens is affixed to the housing, we make sure every part inside the headlight is clean. Whatever dirt or dust remains after this step stays for good.Before the lens is affixed to the housing, we make sure every part inside the headlight is After the epoxy dries, it's time to install the bulb. The bulb is set into the projector; don't push or turn it. Don't touch the glass part of the bulb because the oil on your skin can crack it. There's plastic to hold the bulb in the projector. Push down and turn until it's locked. Careful, they're stubborn.After the epoxy dries, it's time to install the bulb. The bulb is set into the projector; The finished product is ready for installation. The headlights run $110, and the projectors cost $400.The finished product is ready for installation. The headlights run $110, and the projector The ballast goes inside a plastic box to be mounted in the car. We remove the windshield wiper fluid reservoir (not shown) to make room for our driver's side ballast. Two self-tapping sheet metal screws are used to mount the ballast box to the inner fender.We remove the windshield wiper fluid reservoir (not shown) to make room for our driver's s The passenger side has far more room for us to work with. We run new 14-gauge wire in place of the stock headlight harness. The kit provides pigtail plugs for the ballast, which we crimp on with a butt splice.We run new 14-gauge wire in place of the stock headlight harness. The kit provides pigtail The final product: An EG with H.I.D.s. Sweet. CONNECT HIDPlanet.com www.hidplanet.com L-CON engineering Pro Car Parts procarparts.com « | 1 | 2 | 3 | View Full Article Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
