Questions Answered By Honda Expert, Ryan Basseri Of Rywire www.rywire.com
Your Questions Answered
So I was reading your online article about API dropping a J35 into an EG. Would this be legal in California? CARB states that the engine must be from the same type of vehicle. Since the engine is from the Odyssey, wouldn't this be illegal? Well, I was just curious what would be the BEST J series swap I can do to my EG and still be CA legal. Perhaps a J32 motor? Thank you in advance for your time.
K.D. DelaCruz
The first problem with a J35 in California is that it may be in the truck engine category, making it totally illegal. The BEST choice is probably the J32, as it makes great power, and is found in a car of the same maker. Technically, if you can get the car to run with no codes, all the smog equipment installed, and proper matching U.S. spec ECU installed, it can be Ref'd in the state of California.
Hey Guys, thanks for putting out a great magazine, it's the only one I subscribe to and I love it!
I have a 91 CRX that I'm thinking of cramming the big block H22A into, but of course there is a lot to think about. First off, do you guys know the weight of an H22A long block and tranny? Second, is there an aftermarket intake manifold for the H22 that is shorter than stock so I don't have to beat the heck out of my firewall to make room for it? What would you guys think if I were to boost the H22 on a small 16g turbo at stock levels of say 10 lbs? Would that be safe with the FRM liners and stock pistons/rods? Should I upgrade to Mahle pistons and aftermarket rods, or would it be best at those boost levels to go with an iron sleeved block and forged pistons/rods? Lastly, who would you guys recommend to machine my H22? I don't think anybody in my town has experience with many built Hondas, let alone FRM lined ones.
Davey Peters
Central Point, OR Davey, an H22 in a CRX is a cool swap, but in my mind it's really only good as a drag setup. The main reason I feel this way is because it hardly fits in the engine bay, and you cannot set it up in a way that allows you to close the hood while still running a proper axle alignment. The weight difference is not a huge concern; it weighs more but once you upgrade the springs you won't even notice. But if that's what you're after, the main thing I would consider before doing the swap is running an H transmission, or converting to the B transmission with the adapter plate. The who that convert to the B are doing so for the tighter gears, clutch choices, axle angle, and better resource of parts. Many of my customers decide to run the Skunk2 intake manifold with a chipped obd1 ECU. Its single runner design eliminates the butterflies so tuning is necessary. Turbos are a great addition if you are looking to make some serious power! If you are only looking to run low boost you shouldn't really need to do any serious engine internals if you don't want to. A good tuner should be able to make you some good safe power.
Hey Honda Tuning, I was just wondering what the fitting size is on the front and rear calipers on an EK with a swapped disc out back. I didn't know if it was 10mm x 1.00 or not. I can't seem to find anything on the net. Oh yeah, also the IFM fitting that goes into the rubber line; I'm swapping the brake lines with ones that I found in a racing magazine and it's so much cheaper. Thanks a mil.
Corey
Hampton, VA
If I understand you correctly Corey, you're asking about the thread pitch for the brake line into the calipers. It should be an M6X1.0 - (The M stands for metric, 6 is the size, and 1.0 is the thread pitch).